Table of Contents
Advertisement
report-target
Specifies where to send conformance reports for requests.
Syntax
report-target URL
Parameters
URL
Guidelines
The report-target command identifies where to send conformance reports for
requests. This command is meaningful only when the value for the report-level
command is always, failure, or warning.
Examples
v Sends conformance reports for conformance failures for requests to
response-properties-enabled
Controls the enablement of conformance for response messages.
Syntax
response-properties-enabled {on | off}
Parameters
on
off
Guidelines
The response-properties-enabled command determines whether to enable
conformance on response messages.
Examples
v Enables conformance for response messages.
v Does not enable conformance for response messages.
202
Command Reference
# report-level failures
# report-target http://datapower.com/conform
Specifies the location to send conformance reports. Use the following URL
format:
protocol://host/URI
datapower.com/conform with the HTTP protocol.
# report-level failures
# report-target http://datapower.com/conform
Allows the definition of conformance for response messages.
(Default) Does not allow the definition of conformance for response
messages.
# response-properties-enabled on
# response-reject-level failure
#
# response-properties-enabled off
#
Advertisement
Table of Contents
