Table of Contents
Advertisement
Chapter 35. iSCSI Target configuration mode (Type 9235)
This chapter provides an alphabetic listing of commands that are available in iSCSI
Target configuration mode.
To enter this configuration mode, use the Global iscsi-target command.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in iSCSI Target configuration mode.
chap
Assigns an iSCSI CHAP.
Syntax
chap name
Parameters
name
Guidelines
The chap command specifies the name of the existing iSCSI CHAP.
Examples
v Assigns the CHAP-1 CHAP to the Target-1 iSCSI target.
hba
Assigns an iSCSI HBA.
Syntax
hba name
hba{iscsi1 | iscsi2}
Parameters
iscsi1
iscsi2
© Copyright IBM Corp. 1999, 2008
Specifies the name of the existing iSCSI CHAP.
# iscsi-target Target-1
NEW iSCSI Target configuration mode
# chap CHAP-1
#
Specifies the existing iSCSI HBA keyword that identifies the eth1 Ethernet
interface.
Specifies the existing iSCSI HBA keyword that identifies the eth2 Ethernet
interface.
367
Advertisement
Table of Contents
