Table of Contents
Advertisement
Chapter 50. Network Settings configuration mode
This chapter provides an alphabetic listing of commands that are available in
Network Settings configuration mode.
To enter this configuration mode, use the Global network command.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Network Settings configuration
mode.
arp-interval
Sets the time interval between ARP retries.
Syntax
arp-interval interval
Parameters
interval
Related Commands
arp-retries
Examples
v Sets the arp interval to 100 milliseconds.
arp-retries
Sets the number of times the networking system retries a failed ARP request.
Syntax
arp-retries retries
Parameters
retries
Related Commands
arp-interval
© Copyright IBM Corp. 1999, 2008
Specifies the amount of time in milliseconds to wait before retrying a failed
ARP request. Use an integer in the range of 10 through 5000. The default is
50.
# arp-interval 100
#
Specifies the number of times to retry a failed ARP request. Use an integer
in the range from 1 through 64. The default is 8.
489
Advertisement
Table of Contents
