Mode; Mtu - IBM WebSphere XS40 Command Reference Manual

mode

Specifies the operational mode (speed and duplex) for the current Ethernet
interface.
Syntax
mode mode
Parameters
mode
Guidelines
Specifies the operational mode (speed and duplex) for the current Ethernet
interface. On Type 9235 appliances, you cannot change the operational mode
associated with eth1 and eth2.
Related Commands
interface, show interface mode
Examples
v Modifies the Ethernet 0 interface by placing it in 100baseTx full duplex mode.
v Modifies the Ethernet 0 interface by placing it in auto-negotiation mode (the

mtu

Sets an interface-specific maximum transmission unit (MTU).
Syntax
mtu size
Specifies the Ethernet mode using one of the following keywords:
10baseT-FD or 10baseT-HD
Indicates standard Ethernet configuration options.
100baseTx-FD or 100baseTx-HD
Indicates Fast Ethernet configuration options.
1000baseTxFD
Indicates Gigabit Ethernet configuration options.
Auto (Default) Indicates auto-negotiated speed and duplex.
# interface eth0
Interface configuration mode (eth0)
(config-if[eth0]) # mode 100baseTx-FD
Interface operational parameters set (100baseTx-FD)
(config-if[eth0])#
#
default mode).
# interface eth0
Interface configuration mode (eth0)
(config-if[eth0]) # mode Auto
Interface operational parameters set (Auto)
(config-if[eth0])#
#
Chapter 32. Interface configuration mode
355