Table of Contents
Advertisement
loop-detection
Controls loop detection behavior in the network.
Syntax
loop-detection {on | off}
Parameters
on
off
Guidelines
Some protocols provide a loop detection mechanism that can detect network loops.
Loop detection is a good policy, but it runs the risk that the current Multi-Protocol
Gateway might be publicly recorded in a transmitted message. Such visibility
might be considered an information leak.
Use the loop-detection command to specify if the Multi-Protocol Gateway assists
in loop detection within the network.
Related Commands
inject, suppress
Guidelines
When enabled, the Multi-Protocol Gateway inserts a Via: HTTP header that
contains the gateway name in the HTTP transmission.
Examples
v Enables loop-detection and subsequently disables it, which restores the default
max-message-size
Specifies the maximum size of a SOAP or XML message.
Syntax
max-message-size kilobytes
Parameters
kilobytes
# no load-balancer-hash-header
. .
.
# load-balancer-hash-header X-Forwarded-For
#
Enables a loop detection mechanism.
(Default) Disables a loop detection mechanism.
state.
# loop-detection on
. .
.
# loop-detection off
Specifies the maximum message size in kilobytes. Use an integer in the
range of 0 through 2097151. The default is 0. A value of 0 specifies
unlimited size.
Chapter 49. Multi-Protocol Gateway configuration mode
449
Advertisement
Table of Contents
