Table of Contents
Advertisement
wsa-default-replyto
Force the inclusion of the ReplyTo element in Web Services Addressing
(WS-Addressing) messages.
Syntax
wsa-default-replyto replyURL
Parameters
replyURL
Guidelines
The wsa-default-replyto command is relevant when the DataPower service
provides service for WS-Addressing clients (the wsa-mode command is wsa2sync
or wsa2wsa). In these topologies, this command ensures that all messages contain
the WS-Addressing ReplyTo element. This element identifies the recipient endpoint
of a response message.
Because the WS-Addressing specifications do not require the inclusion of the
ReplyTo element, the DataPower service might receive messages that do not
contain a ReplyTo element or that contain the element without a value.
When this happens, the DataPower service modifies the message to include a
ReplyTo element that contains the value specified by the replyURL argument.
If a default recipient endpoint of response messages is not explicitly identified by
this command, the DataPower service provides the following default value:
Related Commands
wsa-mode
Examples
v Specifies http://www.customer.com/PO/inventoryReq/ as the default message
wsa-faultto-rewrite
Assigns or removes a URL Rewrite Policy that rewrites the contents of the Web
Services Addressing (WS-Addressing) FaultTo element.
Syntax
Assign a URL Rewrite Policy
Removes a URL Rewrite Policy
Specifies the value of the ReplyTo element.
http://schemas.xmlsoap.org/ws/2004/08/addressing/role/anonymous
recipient.
# wsa-default-replyto http://www.customer.com/PO/inventoryReq/
#
wsa-faultto-rewrite urlRewritePolicy
no wsa-faultto-write
Chapter 98. Web Service Proxy configuration mode
827
Advertisement
Table of Contents
