Table of Contents
Advertisement
Chapter 19. Failure Notification configuration mode
This chapter provides an alphabetic listing of commands that are available in
Failure Notification configuration mode. To enter this configuration mode, use the
Global failure-notification command.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Failure Notification configuration
mode.
always-on-startup
Indicates whether to send an error report on each firmware restart.
Syntax
always-on-startup {on | off}
on
off
email-address
Provides the email address to which to send error reports.
Syntax
email-address address
Parameters
address Specifies the full email address of the message recipient.
Related Commands
location-id, mode, remote-address
Examples
v Specifies the email address of the recipient.
internal-state
Indicates whether to include a snapshot of the internal state.
Syntax
internal-state {on | off}
on
off
© Copyright IBM Corp. 1999, 2008
Sends the report.
(Default) Does not send the report.
# email-address techsupport@TeraCorp.com
#
Includes the snapshot.
(Default) Does not include the snapshot.
275
Advertisement
Table of Contents
