Table of Contents
Advertisement
Syntax
iscsi-volume name
no iscsi-volume name
Parameters
name
Guidelines
The iscsi-volume command enters iSCSI Volume configuration mode. While in this
configuration mode, create, partition, and name the logical storage volume.
Use the no iscsi-volume command to remove an iSCSI volume.
Related Commands
cancel, exit
loadbalancer-group
Enters Load Balancer Group configuration mode.
Syntax
loadbalancer-group name
no loadbalancer-group name
Parameters
name
Guidelines
After completing configuration of the Load Balancer Group, assign the group to a
specific XML Manager. Assignment of the Load Balancer Group to an XML
Manager makes the group available to the DataPower services that this XML
Manager supports.
Use the no loadbalancer-group command to delete a Load Balancer Group.
Use the exit or cancel command to exit Load Balancer Group configuration mode
and return to Global configuration mode.
Related Commands
cancel, exit, show loadbalancer-group, show loadbalancer-status
locate-device (Type 9235)
Controls the locate LED.
Specifies the name of the iSCSI volume to configure.
The name can contain a maximum of 128 characters. For restrictions, refer
to "Object name conventions" on page xxiv.
Specifies the name of the Load Balancer Group.
The name can contain a maximum of 128 characters. For restrictions, refer
to "Object name conventions" on page xxiv.
Chapter 2. Global configuration mode
57
Advertisement
Table of Contents
