Table of Contents
Advertisement
Chapter 44. Message Duration Monitor configuration mode
This chapter provides an alphabetic listing of commands that are available in
Message Duration Monitor configuration mode.
To enter this configuration mode, use the Global monitor-duration command.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Message Duration Monitor
configuration mode.
Message Duration Monitor configuration mode enables the creation of a duration
monitor, an object that monitors certain transactions associated with a target
message class.
filter
Specifies both a threshold value and a control procedure to implement if the
threshold value is exceeded.
Syntax
filter name average threshold control-procedure
no filter name
Parameters
name
average
threshold
control-procedure
Guidelines
You can add multiple filters to a duration monitor.
After completing the configuration of a duration message monitor, activate the
monitor by assigning it to a DataPower service.
Use the no filter command to remove a filter from an incremental message
monitor.
© Copyright IBM Corp. 1999, 2008
Specifies the name of the filter.
The name can contain a maximum of 32 characters. For restrictions, refer to
"Object name conventions" on page xxiv.
Indicates a required keyword.
Specifies the threshold processing interval in milliseconds. Exceeding this
value triggers the specified control procedure.
Specifies the name of a control procedure that was created with the Global
monitor-action command. This control procedure is triggered if the
threshold value is exceeded.
417
Advertisement
Table of Contents
