Table of Contents
Advertisement
Chapter 113. z/OS NSS Client configuration mode
This chapter provides an alphabetic listing of commands that are available in z/OS
NSS Client configuration mode. To enter this configuration mode, use the Global
zos-nss command.
client-id
Client ID for registration with the NSS server.
Syntax
client-id string
Parameters
string
Guidelines
The client-id command identifies the client ID to register the DataPower appliance
with the NSS server. The NSS client ID is a unique string used by the NSS Server
to track clients. The client ID does not have to correspond to any preexisting
object. It is provided by the NSS client to the server at the time of registration. If
another client attempts to register with the same client ID to the same NSS Server,
the NSS server will send a heartbeat to the first client. If the first client responds to
the heartbeat, the second client's registration will be rejected. If the first client does
not respond, the connect to the first client will be severed and the second client
will be registered.
Related Commands
host, port
host
Identifies the NSS server by host name or IP address.
Syntax
host host
Parameters
host
© Copyright IBM Corp. 1999, 2008
Specifies the client ID to be used for registration with the NSS server.
Minimum length is 1. Maximum length is 24.
Valid characters are:
v a through z
v A through Z
v 0 through 9
v _ (underscore)
v - (dash)
Embedded spaces are invalid.
Specifies the host name or IP address of an NSS server.
943
Advertisement
Table of Contents
