Table of Contents
Advertisement
Chapter 63. RADIUS configuration mode
This chapter provides an alphabetic listing of commands that are available in
RADIUS configuration mode.
To enter this configuration mode, use the Global radius command.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in RADIUS configuration mode.
aaaserver
Identifies a RADIUS AAA server.
Syntax
aaaserver position address [port]
no aaaserver position
Parameters
position
address Specifies the IP address of a RADIUS AAA server.
port
Guidelines
The aaaserver command identifies a RADIUS AAA server, prompts for the secret
unique to this appliance-RADIUS server pair, and adds the server to the list of
RADIUS servers.
Use position to determine the order in which the appliance contacts RADIUS AAA
servers. For example, assume that an appliance has a list of 3 RADIUS AAA
servers, numbered 10, 20, and 30. RADIUS AAA requests are always first sent to
server 10 (the lowest server number being the most preferred). Should the
authentication request timeout, it is next sent to server 20. Should that request
timeout, the request is sent to server 30 (the highest server number is the least
preferred).
Use the no aaaserver command to delete a server from the list of RADIUS servers.
Examples
v Identifies a RADIUS AAA server at 172.16.1.1:1812.
© Copyright IBM Corp. 1999, 2008
Specifies the relative position of this server on the list of RADIUS AAA
servers.
Optionally specifies the port number on IP address that monitors RADIUS
AAA requests. Use an integer in the range of 0 to 65535. The default is
1812.
# aaaserver 20 172.16.1.1 1812
secret: YetAnotherPasswordServer20
#
575
Advertisement
Table of Contents
