Table of Contents
Advertisement
test hardware
Tests the hardware.
Syntax
test hardware
Guidelines
The test hardware command tests the hardware. Depending on the state of the
hardware, the command produces output that states the status for each
component:
v success
v warning
v failure
The components are broken down into the following categories:
v Backtrace availability
v Interface diagnostics
v Fan diagnostics
v Cryptographic card diagnostics
Samples of success statements are as follows:
v [success] Backtrace file does not exist
v [success] 4 interface expected - 4 interfaces found
v [success] MAC address of interface 'eth0' is 00:11:25:27:bf:e7
v [success] Statistics for interface 'eth0' show no errors
v [success] 6 fans expected - 6 fans found
v [success] fan 1 operating within expected range
v [success] Status of the crypto 'standard' is fully operational
Samples of warning statements are as follows:
v [warning] Backtrace file exists.
v [warning] Physical link on interface 'eth0' is down.
v [warning] eth1 has invalid MAC (ff:ff:ff:ff:ff)
Samples of failure statements are as follows:
v [failure] Expected number of interfaces: 4 - Found: 1
v [failure] fan 2 operating outside expected range (rpm too low)
v [failure] Status of crypto 'not detected' is unknown.
The output of the test hardware command is included in any generated error
report.
test logging
Test the configuration of a Log Category.
Syntax
test logging category priority message
116
Command Reference
Advertisement
Table of Contents
