Table of Contents
Advertisement
Related Commands
memory-terminate, timeout
qcode-warn
Specifies the namespace-threshold for QCodes.
Syntax
qcode-warn percent
Parameters
percent Specifies the percentage of available namespace QCodes. Use an integer in
Guidelines
The qcode-warn command specifies the namespace-threshold. This threshold is the
point at which the number of available QCodes fall below the namespace-threshold
(a measure of free QCodes expressed as a percentage of the total QCodes), the
appliance writes an alert to the log. This message indicates that the appliance
detected a shortage of free QCodes. When you receive this alert, the percentage of
available QCodes is below the defined threshold. After you receive this alert,
schedule a system reboot as soon as possible to prevent an unscheduled reboot. If
the available QCodes is less than 5% available, the system reboots.
sensors-log
Controls the collection of environmental log messages.
Syntax
sensors-log {on | off}
Parameters
on
off
Guidelines
The sensors-log command controls the collection of environment log messages.
The firmware monitors system fan speed and power module status. When enabled,
log messages are generated when anomalous conditions are detected.
status-log
Controls the collection of throttle log messages.
Syntax
status-log {on | off}
Parameters
on
674
Command Reference
the range of 5 through 100. The default is 10.
(Default) Enables the collection of environmental log messages.
Disables the collection of environmental log messages.
(Default) Enables throttle settings log messages.
Advertisement
Table of Contents
