Table of Contents
Advertisement
Chapter 8. Compile Options Policy configuration mode
This chapter provides an alphabetic listing of commands that are available in
Compile Options Policy configuration mode.
To enter this configuration mode, use the Global compile-options command. While
in this configuration mode, define the Compile Options Policy. This policy is
intended for use in test or debug environments only. In these environments, this
policy measures the time that is spent processing a specified set of style sheets.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Compile Options Policy
configuration mode.
allow-soap-enc-array
Designates the set of schemas that accept most uses of elements with
xsi:type="SOAP-ENC:Array".
Syntax
allow-soap-enc-array map
Parameters
map
Guidelines
The allow-soap-enc-array command designates a set of schemas that will accept
most uses of elements with xsi:type="SOAP-ENC:Array" consistent with SOAP 1.1
Section 5, even when these attributes violate the XML Schema specification.
Normally the xsi:type attribute must name a type equal to or derived from the
actual type of the element. For schemas compiled with this option, xsi:type is
accepted specifically for the SOAP 1.1 Encoding Array complex type if the
element's type is derived from SOAP-ENC:Array — the opposite of the normal
allowable case.
debug
Identifies set of style sheets to profile in debug mode.
Syntax
debug map
Parameters
map
© Copyright IBM Corp. 1999, 2008
Identifies the URL map that defines the set of schemas that specifically
allow the xsi:type="SOAP-ENC:Array" rule.
Specifies the name of a URL map that defines the set of style sheets.
187
Advertisement
Table of Contents
