Iscsi-Chap (Type 9235); Iscsi-Fs-Init (Type 9235) - IBM WebSphere XS40 Command Reference Manual

iscsi-chap (Type 9235)

Enters iSCSCI CHAP configuration mode.
Syntax
iscsi-chap name
no iscsi-chap name
Parameters
name
Guidelines
The iscsi-chap command enters iSCSCI CHAP configuration mode. While in the
configuration mode, define the credentials for the challenge handshake. During
startup, the firmware uses the CHAP to authenticate the defined user over the
network. After authentication, administrators have access to the iSCSI storage on
the remote server.
Use the no iscsi-chap command to remove an iSCSI CHAP.
Related Commands
cancel, exit, iscsi-hba
Examples
v Enters iSCSCI CHAP configuration mode to create the CHAP-1 iSCSI CHAP.
v Removes the CHAP-1 iSCSI CHAP.

iscsi-fs-init (Type 9235)

Initializes the iSCSI volume.
Syntax
iscsi-fs-init name
Parameters
name
Guidelines
The iscsi-fs-init command initializes an existing iSCSI volume. Before the iSCSI
volume can be initialized, use the admin-state command in iSCSI Volume
configuration mode to disable the volume. After the iSCSI volume is initialized, it
must be enabled for further use.
54
Command Reference
Specifies the name of the iSCSI CHAP.
The name can contain a maximum of 128 characters. For restrictions, refer
to "Object name conventions" on page xxiv.
# iscsi-chap CHAP-1
New iSCSI CHAP configuration
#
# no iscsi-chap CHAP-1
iscsi-chap CHAP-1 - Configuration deleted.
#
Specifies the name of the iSCSI volume to initialize.