Initial Setup And Configuration; Setting The Date And Time - IBM TotalStorage NAS 300 User Reference

You are now ready to begin administering the appliance. Details for this task are
described in "Initial setup and configuration".

Initial setup and configuration

This section provides details on the initial setup and configuration of the NAS
Gateway 300.
Note that if you are administering the NAS Gateway 300 without a keyboard,
monitor, and mouse ("headless" mode), you can use one of two methods:
v Terminal Services, which provides full administrative function. (See "Terminal
v Windows 2000 for Network Attached Storage, which provides a subset of the full
In general, you administer the appliance by adjusting information contained in the
following task groups:
Note: In this example, you access the task groups through the Windows 2000 for
v "Setting the date and time"
v "Setting up the network" on page 11
Although you can modify multiple appliance and network attributes in each task
group, the information given here is the minimum you need to know to administer
the appliance and network.
You can find more information on administration elsewhere in this book and in the
online help.
You can access these task groups in one of three ways:
1. Click the Home tab and then select the task group link.
2. Click the top tab associated with that task group.
3. Click the Back button on the browser until you arrive Home and then select the

Setting the date and time

To change the date and time, click Date and Time. (Remember that you can also
access all of these task groups by clicking the titled tabs at the top of the page.)
The Set Date and Time page appears, allowing you to adjust information as
necessary.
10
NAS Gateway 300 User's Reference
Services and the IBM NAS Administration console" on page 15.)
administrative function in Terminal Services. (See "Windows 2000 for Network
Attached Storage" on page 23.)
Network Attached Storage Web-based GUI.
task group link.