Table of Contents
Advertisement
Related Commands
wsrm, wsrm-destination-accept-offers, wsrm-source-exponential-backoff,
wsrm-source-request-create-sequence, wsrm-source-response-create-sequence
wsrm-source-retransmit-count
Specifies the number of times to retransmit a message.
Syntax
wsrm-source-retransmit-count count
Parameters
count
Guidelines
The wsrm-source-retransmit-count command specifies the number of times a
Reliable Messaging source retransmits a message before declaring a failure.
This command also controls the retransmission of CreateSequence requests.
Related Commands
wsrm, wsrm-destination-accept-offers, wsrm-source-request-create-sequence,
wsrm-source-response-create-sequence
wsrm-source-sequence-ssl
Indicates whether to use an SSL session binding to protect sequence lifecycle
messages.
Syntax
wsrm-source-sequence-ssl {on | off}
Parameters
on
off
Guidelines
All Reliable Messaging control messages and sequence messages are bound to the
original SSL/TLS session that is created by the Reliable Messaging source to
transmit the CreateSequence control message. Sequence messages that are received
by the Reliable Messaging destination with the correct identifier but on a different
SSL/TLS session are rejected.
The lifetime of a SSL/TLS protected sequence is bound by the lifetime of the
SSL/TLS session this is used to protect that sequence.
Related Commands
wsrm
Specifies the number of retransmissions. Use and integer in the range of 1
through 256. The default is 4.
Uses an SSL session binding.
(Default) Does not use an SSL session binding.
Chapter 98. Web Service Proxy configuration mode
847
Advertisement
Table of Contents
