Table of Contents
Advertisement
Chapter 69. SLM Policy configuration mode
This chapter provides an alphabetic listing of commands that are available in SLM
Policy configuration mode. SLM is the abbreviation for Service Level Monitor.
To enter this configuration mode, use the Global slm-policy command.
Many of the commands that are listed in "Common commands" on page 2 and
most, but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in SLM Policy configuration mode.
eval-method
Specifies the behavior when an action is triggered.
Syntax
eval-method behavior
no eval-method
Parameters
behavior
Guidelines
Use the no eval-method command to delete the current behavior.
Examples
v Creates the SLM-Policy-1 SLM Policy. Specifies that Policy processing ceases
v Deletes the current behavior and assigns the execute-all-statements behavior.
© Copyright IBM Corp. 1999, 2008
Specifies the SLM Policy. Use one of the following keywords:
execute-all-statements
Indicates that policy execution continues until all associated
statements are evaluated.
terminate-at-first-action
Indicates that policy execution ceases upon the triggering of any
action by an associated statement.
terminate-at-first-reject
Indicates that policy execution ceases upon the triggering of any
action that drops traffic by an associated statement.
when a called action drops traffic.
# action SLM-Policy-1
SLM Policy configuration mode
# eval-method terminate-at-first-reject
#
# action SLM-Policy-1
SLM Policy configuration mode
# no eval-method
# eval-method execute-all-statements
625
Advertisement
Table of Contents
