Table of Contents
Advertisement
Parameters
limit
Guidelines
The wsrm-source-maximum-sequences command sets a limit on the maximum
number of simultaneously active sequences from Reliable Messaging sources of
this DataPower server. Each remote Reliable Messaging destination endpoint
reference (URL) requires one sequence. Transactions that request the creation of
sequences in excess of this limit result in a SOAP Fault. This property controls
memory resource utilization.
Related Commands
wsrm
wsrm-source-request-ack-count
Specifies the number of messages to send before requesting acknowledgement.
Syntax
wsrm-source-request-ack-count numberOfMessages
Parameters
numberOfMessages
Guidelines
The wsrm-source-request-ack-count command specifies the number of messages
that the a Reliable Messaging source sends before including the AckRequested
SOAP header to request an acknowledgement.
Related Commands
wsrm, wsrm-destination-accept-offers, wsrm-source-request-create-sequence,
wsrm-source-response-create-sequence
wsrm-source-request-create-sequence
Indicates whether to create a source from the backend to the server.
Syntax
wsrm-source-request-create-sequence {on | off}
Parameters
on
off
Guidelines
The wsrm-source-request-create-sequence command indicates whether to create a
Reliable Messaging source from the backend to the server when there is SOAP data
Specifies the number of simultaneous active sequence. Use an integer in
the range of 1 through 2048. The default is 400.
Use an integer in the range of 1 through 256. The default is 1.
Creates a Reliable Messaging source.
(Default) Does not create a Reliable Messaging source.
Chapter 98. Web Service Proxy configuration mode
845
Advertisement
Table of Contents
