Table of Contents
Advertisement
Parameters
minutes
Guidelines
You must specify a refresh interval when defining either an HTTP-enabled or
LDAP-enabled CRL Update Policy.
Related Commands
bind-dn, bind-pass, fetch-URL, read-dn, remote-address
Examples
v Enters CRL Mode to create the LDAP1440L DAP-enabled CRL Update Policy. The
v Enters CRL Mode to create the HTTP30 HTTP-enabled CRL Update Policy. The
remote-address
Specifies the address of the LDAP server.
Syntax
remote-address server [port]
Parameters
server
port
Guidelines
You must specify a server IP address to define an LDAP-enabled CRL Update
Policy.
Related Commands
bind-dn, bind-pass, read-dn, refresh
210
Command Reference
Specifies the interval in minutes between CRL updates.
ragnarok LDAP server (with default port 389) is accessed with the account name
of X and a password of 1PAss$WorD. The target certificate is issued by VeriSign
Australia and is refreshed on daily.
# crl LDAP1440 ldap
Entering CRL mode for 'LDAP1440'
# bind-dn X
# bind-pass 1PAss$WorD
# read-dn "C=AU,
ST=Victoria, L=South Melbourne, O=VeriSign Australia
Limited, OU=IT Department, CN=www.verisign.com.au"
# remote-address ragnarok
# refresh 1440
#
target CRL is retrieved from the specified URL and refreshed every half hour.
# crl HTTP30 http
Entering CRL mode for 'HTTP30'
# fetch-URL http://crl.verisign.com/ATTClass1Individual.crl
# refresh 30
#
Specifies the host name or IP address of the LDAP server.
Identifies the server port that monitors LDAP traffic. Use an optional
integer in the range of 0 through 65535. The default is 389.
Advertisement
Table of Contents
