Table of Contents
Advertisement
Chapter 34. iSCSI Host Bus Adapter configuration mode (Type
9235)
This chapter provides an alphabetic listing of commands that are available in iSCSI
Host Bus Adapter configuration mode. To enter this configuration mode, use the
Global iscsi-hba command.
All Type 9235 appliances have two Host Bus Adapters. Each adapter has a "burned
in" iSCSI qualified name (IQN). The only required configuration is to define the
network connectivity. Use either DHCP or specify the IP address and default
gateway.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in iSCSI Host Bus Adapter
configuration mode.
dhcp
Indicates whether to use DHCP.
Syntax
dhcp {on| off}
Parameters
on
off
Guidelines
The dhcp command specifies whether to use DHCP.
v When enabled, values for the ip-address and ip default-gateway commands are
v When disabled, define the network connection for the HBA with the ip-address
Related Commands
ip-address, ip default-gateway
Examples
v Enables DHCP for the iscsi-1 HBA.
v Disables DHCP for the iscsi-1 HBA.
© Copyright IBM Corp. 1999, 2008
Enables DHCP.
(Default) Disables DHCP.
ignored.
and ip default-gateway commands.
# iscsi-hba iscsi-1
Modify iSCSI Host Bus Adapter configuration
# dhcp on
#
# iscsi-hba iscsi-1
Modify iSCSI Host Bus Adapter configuration
# dhcp off
#
363
Advertisement
Table of Contents
