Table of Contents
Advertisement
When the mode command exposes the SLM Endpoint (slm keyword), you can use
the slm-peering command to indicate the frequency to update SLM peers.
Related Commands
slm-peering
Examples
v Changes the default modes to include the WS-Management Endpoint service
port
Identifies the local port to monitor for incoming requests.
Syntax
port port
Parameters
port
Related Commands
local-address
Examples
v Configure the XML Management Interface on port 1080 of the specified interface.
slm-peering
Specifies the frequency to issue SLM peer-group updates.
Syntax
slm-peering seconds
Parameters
seconds
Guidelines
The slm-peering is required when the XML Management Interface exposes the
SLM Endpoint.
and the WSDM Endpoint service.
# xml-mgmt
Modify XML Management Interface configuration
# mode any+soma+v2004+amp+slm+wsm+wsdm
#
Identifies the listening port on the appliance that monitors SOAP/XML
management traffic. The default is 5050.
# xml-mgmt
Modify XML Management Interface configuration
# local-address 10.10.13.7
# port 1080
#
Specifies the number of seconds between SLM peer-group updates. The
default is 10.
Chapter 107. XML Management Interface configuration mode
917
Advertisement
Table of Contents
