Table of Contents
Advertisement
Chapter 24. Hard Disk Array configuration mode (Type 9235)
This chapter provides an alphabetic listing of commands that are available in Hard
Disk Array configuration mode. To enter this configuration mode, use the Global
raid-volume command.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Hard Disk Array configuration
mode.
directory
Specifies the name of the directory.
Syntax
directory name
Parameters
name
Guidelines
The directory command specifies the directory under which to make the files on
the hard disk array available in the local: and logstore: directories in each
application domain.
Examples
v Makes the files on the hard disk array accessible in the local:///disk and
read-only
Sets the files on the hard disk array to read-only access.
Syntax
read-only
no read-only
Guidelines
The read-only command sets the files on the hard disk array to read-only access.
The default is read-write.
Examples
v Makes the file system read-only.
© Copyright IBM Corp. 1999, 2008
Specifies the name of the subdirectory.
logstore:///disk directories.
# raid-volume raid0
Hard Disk Array configuration mode
# directory disk
#
315
Advertisement
Table of Contents
