Table of Contents
Advertisement
Chapter 74. Stateful Raw XML Handler configuration mode
This chapter provides an alphabetic listing of commands that are available in
Stateful Raw XML Handler configuration mode.
To enter this configuration mode, use the Global source-stateful-tcp command.
While in this mode, define the client-side traffic handler.
All of the commands listed in "Common commands" on page 2 and most, but not
all, of the commands listed in Chapter 114, "Monitoring commands," on page 949
are available in these configuration modes.
acl
Assigns an Access Control List (ACL).
Syntax
acl name
no acl name
Parameters
name
Guidelines
Only those IP addresses explicitly granted access by the assigned ACL are able to
access the Stateful Raw XML Handler.
Use the no acl command to remove an ACL from a Stateful Raw XML Handler.
Examples
v Enters Stateful Raw XML Handler configuration mode to create the avecTCP
v Removes the aclRestrictive ACL from the current Stateful Raw XML Handler.
close-on-fault
Controls session behavior in the event of a fault condition.
Syntax
close-on-fault {on | off}
© Copyright IBM Corp. 1999, 2008
Identifies the ACL to be assigned to the Stateful Raw XML Handler.
Stateful Raw XML Handler. Assigns the designated ACL to the handler.
# source-stateful-tcp avecTCP
New Stateful Raw XML Handler configuration
# acl aclRestrictive-1
#
# no acl aclRestrictive-1
#
645
Advertisement
Table of Contents
