Hw-Module Logging Onboard - Cisco MDS 9000 series Command Reference Manual

Chapter 10 H Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

hw-module logging onboard

To configure on-board failure logging (OBFL), use the hw-module logging onboard command. To
disable this feature, use the no form of the command.
Syntax Description
module slot
log-type
cpu-hog
environmental-history
error-stats
interrupt-stats
mem-leak
miscellaneous-error
obfl-log
Defaults Enabled.
Command Modes Configuration mode.
Command History Release
3.0(1)
Usage Guidelines OBFL data uses the module's persistent logging facility to store data in its CompactFlash memory. When
OBFL is disabled, the persistent logging facility discards all entries sent to it for logging.
Examples
The following example configures on-board failure logging of memory leak events on module 2.
switch# config terminal
switch(config)# hw-module logging onboard module 2 mem-leak
Related Commands Command
clear logging onboard
show logging onboard Displays OBFL information.
OL-8413-07, Cisco MDS SAN-OS Release 3.x
hw-module logging onboard [module slot] [log-type]
no hw-module logging onboard [module slot] [log-type]
Modification
This command was introduced.
Description
Clears OBFL information.
Configures OBFL for a specified module.
Specifies the type of events for on-board failure logging.
Specifies cpu hog events.
Specifies environmental history events.
Specifies error statistics events.
Specifies interrupt statistics events.
Specifies memory leak events.
Specifies miscellaneous information events.
Specifies boot uptime, device version, and OBFL history.
hw-module logging onboard
Cisco MDS 9000 Family Command Reference
10-5