Errdisable Recovery - Cisco ME 3800X Command Reference Manual

errdisable recovery

errdisable recovery
To configure the recover mechanism variables, use the errdisable recovery command in global
configuration mode. To return to the default setting, use the no form of this command.
Although visible in the command-line help, the dhcp-rate-limit and psecure-violation keywords are
Note
not supported.
Syntax Description
cause
all
bpduguard
channel-misconfig
gbic-invalid
link-flap
loopback
mac-limit
oam-remote failure
pagp-flap
port-mode failure
ppoe-ia-rate-limit
udld
unicast-flood
Cisco ME 3800X and ME 3600X Switch Command Reference
2-68
errdisable recovery {cause {all | bpduguard | channel-misconfig | gbic-invalid | link-flap |
loopback | mac-limit | pagp-flap | oam-remote failure | port-mode failure |
ppoe-ia-rate-limit | storm-control | unicast-flood | | udld} | {interval interval}
no errdisable recovery {cause {all | bpduguard | channel-misconfig | gbic-invalid | link-flap |
loopback | mac-limit | pagp-flap | oam-remote failure | port-mode failure |
ppoe-ia-rate-limit | storm-control | unicast-flood | | udld} | {interval interval}
Enables the error-disabled mechanism to recover from a specific cause.
Enables the timer to recover from all error-disabled causes.
Enables the timer to recover from the bridge protocol data unit (BPDU) guard
error-disabled state.
Enables the timer to recover from the EtherChannel misconfiguration
error-disabled state.
Enables the timer to recover from an invalid Gigabit Interface Converter
(GBIC) module error-disabled state.
Note
Enables the timer to recover from the link-flap error-disabled state.
Enables the timer to recover from a loopback error-disabled state.
Enables the timer to recover from the MAC limit disable state.
Enables the timer to recover from an Ethernet Operations, Administration,
and Maintenance (OAM) detected remote failure.
Enables the timer to recover from the Port Aggregation Protocol (PAgP)-flap
error-disabled state.
Enables the timer to recover from port mode change
Enables the timer to recover from Point-to-Point Protocol over Ethernet
(PPPoE) IA rate-limit.
Enables the timer to recover from the UniDirectional Link Detection (UDLD)
error-disabled state.
Enables the timer to recover from the unicast flood disable state.
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
This error refers to an invalid small form-factor pluggable (SFP)
error-disabled state.
OL-28238-01