Debug Lacp - Cisco Catalyst 2960 Command Reference Manual

Appendix B Catalyst 2960 Switch Debug Commands

debug lacp

Use the debug lacp privileged EXEC command to enable debugging of Link Aggregation Control
Protocol (LACP) activity. Use the no form of this command to disable debugging.
Syntax Description
all
event
fsm
misc
packet
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(25)FX
Usage Guidelines
The undebug lacp command is the same as the no debug lacp command.
Related Commands Command
show debugging
show lacp
78-16882-01
debug lacp [all | event | fsm | misc | packet]
no debug lacp [all | event | fsm | misc | packet]
(Optional) Display all LACP debug messages.
(Optional) Display LACP event debug messages.
(Optional) Display LACP finite state-machine debug messages.
(Optional) Display miscellaneous LACP debug messages.
(Optional) Display LACP packet debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Displays LACP channel-group information.
Catalyst 2960 Switch Command Reference
debug lacp
B-15