Figure 41: Connecting the ACX Router to a Management Console Through a Console Server
CON
To Console Port
Figure 42: Connecting the ACX Router Directly to a Management Console
CON
ETH CRAFT
port (on device)
SEE ALSO
Console Port Connector Pinouts for an ACX5000 Router | 97
Connecting an ACX5000 Router to a Network for Out-of-Band Management
You can monitor and manage the ACX5000 router using a dedicated management channel. ACX5000
routers have a minimum of two management ports: a 10/100/1000BASE-T RJ-45 port and a 1-Gbps SFP
ports. Some product SKUs have an additional 1-Gbps SFP port that can be used either for fiber or copper
connections. Use the management ports to connect the ACX5000 router to a network for out-of-band
management.
CAUTION:
supported.
NOTE:
You cannot use the management ports to perform the initial configuration of the ACX5000
router. You must configure the management ports before you can successfully connect to the
ACX5000 router using these ports. See
Laptop CPU
Laptop CPU
Configuring the two management interfaces within the same subnet is not
"Initially Configuring the ACX5000 Router" on page
121
122.