Connecting An Ex Series Switch To A Network For Out-Of-Band Management - Juniper EX2200 Series Hardware Manual

Related
Documentation

Connecting an EX Series Switch to a Network for Out-of-Band Management

Copyright © 2011, Juniper Networks, Inc.
Secure the ring lug of the negative (–) DC power source cable to the A– or B–
b.
terminal on the DC power supply.
Tighten the screws on the power supply terminals until snug using the screwdriver.
c.
Do not overtighten—apply between 8 in.-lb (0.9 Nm) and 9 in.-lb (1.02 Nm) of
torque to the screws.
To connect the power supply to two power sources:
Secure the ring lug of the positive (+) DC power source cable from the first DC
a.
power source to the A+ terminal on the power supply.
Secure the ring lug of the negative (–) DC power source cable from the first DC
b.
power source to the A– terminal on the power supply.
Secure the ring lug of the positive (+) DC power source cable from the second
c.
DC power source to the B+ terminal on the power supply.
Secure the ring lug of the negative (–) DC power source cable from the second
d.
DC power source to the B– terminal on the power supply.
Tighten the screws on the power supply terminals on both the power supplies
e.
until snug using the screwdriver. Do not overtighten—apply between 8 in.-lb
(0.9 Nm) and 9 in.-lb (1.02 Nm) of torque to the screws.
Hook the plastic cover on one side of the terminal block and gently flex it inwards to
5.
hook it on the other side also.
Close the input circuit breaker.
6.
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 129
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 131
Power Supply in EX2200 Switches on page 18
This topic applies to multiple hardware devices in the EX Series product family, which
includes switches and the XRE200 External Routing Engine.
You can monitor and manage these devices using a dedicated management channel.
Each device has a management port with an RJ-45 connector for out-of-band
management. Use the management port to connect the EX Series switch or external
Routing Engine to the management device.
Ensure that you have an Ethernet cable with an RJ-45 connector available. One such
cable is provided with the device.
the Ethernet cable supplied with the device.
Chapter 10: Connecting the Switch
Figure 50 on page 114 shows the RJ-45 connector of
113