Connecting To A Management Console Or Auxiliary Device; Connecting To A Network For Out-Of-Band Management; Figure 27: Console And Auxiliary Serial Port Connector; Figure 28: Routing Engine Management Ports - Juniper M10i Hardware Manual

M10i Multiservice Edge Router Hardware Guide

Connecting to a Management Console or Auxiliary Device

Related
Documentation

Connecting to a Network for Out-of-Band Management

62
All manuals and user guides at all-guides.com
To use a system console to configure and manage the Routing Engine, connect it to the
port on the Routing Engine. To use a laptop, modem, or other auxiliary device,
CONSOLE
connect it to the appropriate
an RS-232 (EIA-232) serial cable with DB-9/DB-9 connectors. One cable is provided
with the router. If you want to connect a device to both ports, you must supply another
cable. See "Routing Engine Interface Cable and Wire Specifications for M10i Routers" on
page 200. To connect a management console or auxiliary device:
Turn off the power to the console or auxiliary device.
1.
Plug the female end (shown in Figure 27 on page 62) of the provided console cable
2.
into the or
CONSOLE AUX/MODEM
Using a 2.5 mm flat-blade screwdriver, tighten the screws on the connector.
3.
Attach the other end of the cable to the console or auxiliary device.
4.

Figure 27: Console and Auxiliary Serial Port Connector

Figure 28: Routing Engine Management Ports

M10i Chassis Description on page 5
M10i Routing Engine 400 Description on page 18
M10i Routing Engine 850 Description on page 19
M10i Routing Engine Interface Ports on page 17
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet cable with RJ-45/RJ-45 connectors to the
One such cable is provided with the router. For cable specifications, see "Routing Engine
Interface Cable and Wire Specifications for M10i Routers" on page 200:
Turn off the power to the management device.
1.
Plug one end of the Ethernet cable (Figure 29 on page 63 shows the connector) into
2.
the port on the Routing Engine (see Figure 30 on page 63).
MGMT
Plug the other end of the cable into the network device.
3.
port on the Routing Engine. Both ports accept
AUX/MODEM
port (see Figure 28 on page 62).
MGMT
Copyright © 2010, Juniper Networks, Inc.
port on the Routing Engine.