Connecting The Acx4000 Router To Management Devices; Connecting The Router To A Network For Out-Of-Band Management - Juniper ACX4000 Hardware Manual

Connecting the ACX4000 Router to Management Devices

IN THIS SECTION

Connecting the Router to a Network for Out-of-Band Management | 107

Connecting the Router to a Management Console or Auxiliary Device | 108
To connect external devices and cables to the router, you need the following tools:
• RJ-45 Ethernet cable and RJ-45 to DB-9 serial port adapter (provided)
• Management host, such as a PC, with an Ethernet port (not provided)
Connecting the Router to a Network for Out-of-Band Management
To connect to the MGMT port on the ACX4000 router:
1. Turn off the power to the management device.
2. Plug one end of the Ethernet cable into the MGMT port on the router.
connector. Figure 2 shows the port.)
(Figure 1 shows the
107