Table of Contents
Advertisement
Step 4: Connect External Devices and Cables
IN THIS SECTION
Tools Required to Connect External Devices and Cables | 14
Connect the ACX Series Router to a Network for Out-of-Band Management | 14
Connect the ACX Series Router to a Management Console or Auxiliary Device | 15
Connect Network Interface Cables to the ACX Series Router | 15
Figure 9: Ethernet Cable Connector
Tools Required to Connect External Devices and Cables
To connect external devices and cables to the router, you need the following tools:
Ethernet cable with an RJ-45 connector attached (provided)
RJ-45 to DB-9 serial port adapter (provided)
Management host, such as a PC, with an Ethernet port (not provided)
Connect the ACX Series Router to a Network for Out-of-Band Management
1. Turn off the power to the management device.
2. Plug one end of the Ethernet cable
on the front of the chassis.
the port.
3. Plug the other end of the cable into the network device.
All manuals and user guides at all-guides.com
(Figure 9 on page 14
Figure 1 on page
4,
Figure 2 on page
shows the connector) into the MGMT port
4, and
Figure 3 on page 5
14
show
Advertisement
Table of Contents
