Step 6: Connect External Devices And Line Card Cables; Connect To A Network For Out-Of-Band Management; Connect A Management Console; Connect The Line Card Cables - Juniper MX2020 Quick Start Manual

Step 6: Connect External Devices and Line Card Cables

Connect to a Network for Out-of-Band Management

Connect a Management Console

Connect the Line Card Cables

Copyright © 2015, Juniper Networks, Inc.
Figure 31: Connecting External Devices and MPC Cables
0
10
11
12
13
14
15
16
17
18 19
Connect to a Network for Out-of-Band Management on page 45
Connect a Management Console on page 45
Connect the Line Card Cables on page 45
Turn off the power to the management device.
1.
Plug one end of an RJ-45 Ethernet cable into the
2.
Plug the other end of the cable into the network device.
3.
Turn off the power to the management device.
1.
Plug one end of an RJ-45 Ethernet cable into the
2.
Plug the female DB-9 adapter end of the cable into the device's serial port.
3.
Have ready a length of the type of cable used by the MPCs or MICs. For cable
1.
specifications, see the
MX Series Interface Module Reference
If the cable connector port is covered by a rubber safety plug, remove the plug.
2.
Step 6: Connect External Devices and Line Card Cables
port on the CB-RE.
ETHERNET
or
CONSOLE AUX
.
port on the CB-RE.
45