Reload (Stack); Show Slot - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

no set slot power
This command unconfigures the power mode of the slot(s) and prohibits power from being
supplied to a card located in the slot. If you specify [all], the command prohibits power to all
slots, otherwise the command prohibits power to the slot identified by <unit/slot>.
Use this command when installing or removing cards. If a card or other module is present in this
slot, power is prohibited to the contents of the slot. If the slot is empty, power is prohibited to any
card inserted into the slot.
Format
no set slot power [<unit/slot> | all]
Mode Global Config

reload (Stack)

This command resets the entire stack or the identified <unit>. The <unit> is the switch
identifier. The system prompts you to confirm that you want to reset the switch.
Format
reload [<unit>]
Mode User EXEC

show slot

This command displays information about all the slots in the system or for a specific slot.
Format
show slot [<unit/slot>]
Mode User EXEC
Term Definition
Slot The slot identifier in a <unit/slot> format.
Slot Status The slot is empty, full, or has encountered an error
Admin State The slot administrative mode is enabled or disabled.
Power State The slot power mode is enabled or disabled.
Configured Card The model identifier of the card preconfigured in the slot. Model Identifier is a 32-
Model Identifier
character field used to identify a card.
Stacking Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
2-6