Ip Igmp Query-Max-Response-Time; Ip Igmp Robustness - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

ip igmp query-max-response-time

This command configures the maximum response time interval for the specified interface, which
is the maximum query response time advertised in IGMPv2 queries on this interface.The time
interval is specified in tenths of a second. The range for <maxresptime> is 0 to 255 tenths of a
second.
Default 100
Format
ip igmp query-max-response-time <seconds>
Mode Interface Config
no ip igmp query-max-response-time
This command resets the maximum response time interval for the specified interface, which is the
maximum query response time advertised in IGMPv2 queries on this interface to the default value.
The maximum response time interval is reset to the default time.
Format
no ip igmp query-max-response-time
Mode Interface Config

ip igmp robustness

This command configures the robustness that allows tuning of the interface. The robustness is the
tuning for the expected packet loss on a subnet. If a subnet is expected to have a lot of loss, the
Robustness variable may be increased for the interface. The range for <robustness> is 1 to
255.
Default 2
Format
ip igmp robustness <robustness>
Mode Interface Config
no ip igmp robustness
This command sets the robustness value to default.
Format
no ip igmp robustness
Mode Interface Config
IP Multicast Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
5-29