Port-Channel Static - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Note: This command is only applicable to physical interfaces.
no lacp partner system priority
Use this command to configure the default administrative value of priority associated with the
Partner's System ID.
Format
no lacp partner system priority
Mode Interface Config

port-channel static

This command enables the static mode on a port-channel (LAG) interface. By default the static
mode for a new port-channel is disabled, which means the port-channel is dynamic. However if the
maximum number of allowable dynamic port-channels are already present in the system, the static
mode for a new port-channel enabled, which means the port-channel is static.You can only use this
command on port-channel interfaces.
Default disabled
Format
port-channel static
Mode Interface Config
no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the default
value. This command will be executed only for interfaces of type port-channel (LAG).
Format
no port-channel static
Mode Interface Config
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-103