Ip Ospf Authentication; Ip Ospf Cost - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

ip ospf authentication

This command sets the OSPF Authentication Type and Key for the specified interface. The value
of <type> is either none, simple or encrypt. The <key> is composed of standard displayable,
non-control keystrokes from a Standard 101/102-key keyboard. The authentication key must be 8
bytes or less if the authentication type is simple. If the type is encrypt, the key may be up to 16
bytes. If the type is encrypt a <keyid> in the range of 0 and 255 must be specified.
Unauthenticated interfaces do not need an authentication key or authentication key ID. There is no
default value for this command.
Format
ip ospf authentication {none | {simple <key>} | {encrypt <key>
<keyid>}}
Mode Interface Config
no ip ospf authentication
This command sets the default OSPF Authentication Type for the specified interface.
Format
no ip ospf authentication
Mode Interface Config

ip ospf cost

This command configures the cost on an OSPF interface. The <cost> parameter has a range of 1
to 65535.
Default 10
Format
ip ospf cost <1-65535>
Mode Interface Config
no ip ospf cost
This command configures the default cost on an OSPF interface.
Format
no ip ospf cost
Mode Interface Config
Routing Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
4-56