Ipv6 Route Distance; Ipv6 Mtu - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Format
no ipv6 route <ipv6-prefix>/<prefix_length> [{<next-hop-address> |
Null0 | interface {<unit/slot/port> | tunnel <tunnel_id>} <next-hop-
address> | <preference>}]
Mode Global Config

ipv6 route distance

This command sets the default distance (preference) for IPv6 static routes. Lower route distance
values are preferred when determining the best route. The ipv6 route command allows you to
optionally set the distance (preference) of an individual static route. The default distance is used
when no distance is specified in this command.
Changing the default distance does not update the distance of existing static routes, even if they
were assigned the original default distance. The new default distance will only be applied to static
routes created after invoking the ipv6 route distance command.
Default 1
Format
ipv6 route distance <1-255>
Mode Global Config
no ipv6 route distance
This command resets the default static route preference value in the router to the original default
preference. Lower route preference values are preferred when determining the best route.
Format
no ipv6 route distance
Mode Global Config

ipv6 mtu

This command sets the maximum transmission unit (MTU) size, in bytes, of IPv6 packets on an
interface. This command replaces the default or link MTU with a new MTU value.
Note: The default MTU value for a tunnel interface is 1480. You cannot change this value.
IPv6 Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
7-14