If option <changed> is used, this command displays/capture commands with settings/
configurations that differ from the defaul value.
•
If all the flags in a particular group are enabled, then the command displays trapflags
<group name> all.
•
If some, but not all, of the flags in that group are enabled, the command displays trapflags
<groupname> <flag-name>.
Format
show running-config [all | <scriptname> | changed]
Mode
Privileged EXEC
show running-config interface
This command shows the current configuration on a particular interface. The interface could be a
physical port or a virtual port—like a LAG or VLAN. The output captures how the configuration
differs from the factory default value.
Format
show running-config interface {<unit/slot/port>} | VLAN <id> | LAG <id>}
Mode
Interface Config
show sysinfo
This command displays switch information.
Format
show sysinfo
Mode
Privileged EXEC
Term
Definition
Switch
Text used to identify this switch.
Description
System Name
Name used to identify the switch.The factory default is blank. To configure the system
name, see
System Location Text used to identify the location of the switch. The factory default is blank. To configure
the system location, see
System Contact Text used to identify a contact person for this switch. The factory default is blank. To
configure the system location, see
System Object ID The base object ID for the switch's enterprise MIB.
System Up Time The time in days, hours and minutes since the last switch reboot.
Utility Commands
"snmp-server" on page
10-41.
"snmp-server" on page
"snmp-server" on page
v1.0, July 2009
Managed Switch CLI Manual, Release 8.0
10-41.
10-41.
9-16