Area Default-Cost (Ospf); Area Nssa (Ospf); Area Nssa Default-Info-Originate (Ospf) - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

area default-cost (OSPF)

This command configures the default cost for the stub area. You must specify the area ID and an
integer value between 1-16777215.
Format
area <areaid> default-cost <1-16777215>
Mode Router OSPF Config

area nssa (OSPF)

This command configures the specified areaid to function as an NSSA.
Format
area <areaid> nssa
Mode Router OSPF Config
no area nssa
This command disables nssa from the specified area id.
Format
no area <areaid> nssa
Mode Router OSPF Config

area nssa default-info-originate (OSPF)

This command configures the metric value and type for the default route advertised into the
NSSA. The optional metric parameter specifies the metric of the default route and is to be in a
range of 1-16777214. If no metric is specified, the default value is 10. The metric type can be
comparable (nssa-external 1) or non-comparable (nssa-external 2).
Format
area <areaid> nssa default-info-originate [<metric>] [{comparable |
non-comparable}]
Mode Router OSPF Config
Routing Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
4-42