Using Cli Help - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Table 8. CLI Editing Conventions (continued)
Key Sequence
Ctrl-Q
Ctrl-S
Ctrl-Z
Tab, <SPACE>
Exit
?

Using CLI Help

Enter a question mark (?) at the command prompt to display the commands available in the current
mode.
(switch) >?
enable
help
logout
ping
quit
show
telnet
Enter a question mark (?) after each word you enter to display available command keywords or
parameters.
(switch) #network ?
javamode
mgmt_vlan
parms
protocol
If the help output shows a parameter in angle brackets, you must replace the parameter with a
value.
(switch) #network parms ?
<ipaddr>
Using the Command-Line Interface
Description
Enables serial flow
Disables serial flow
Return to root command prompt
Command-line completion
Go to next lower command prompt
List available commands, keywords, or parameters
Enter into user privilege mode.
Display help for various special keys.
Exit this session. Any unsaved changes are lost.
Send ICMP echo packets to a specified IP address.
Exit this session. Any unsaved changes are lost.
Display Switch Options and Settings.
Telnet to a remote host.
Enable/Disable.
Configure the Management VLAN ID of the switch.
Configure Network Parameters of the router.
Select DHCP, BootP, or None as the network config
protocol.
Enter the IP address.
v1.0, July 2009
Managed Switch CLI Manual, Release 8.0
1-11