NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual page 584

netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host Configuration
Protocol (DHCP) clients.type Specifies the NetBIOS node type. Valid types are:
• b-node—Broadcast
• p-node—Peer-to-peer
• m-node—Mixed
• h-node—Hybrid (recommended)
Default none
Format
netbios-node-type <type>
Mode DHCP Pool Config
no netbios-node-type
This command removes the NetBIOS node Type.
Format
no netbios-node-type
Mode DHCP Pool Config
next-server
This command configures the next server in the boot process of a DHCP client.The <address>
parameter is the IP address of the next server in the boot process, which is typically a TFTP server.
Default inbound interface helper addresses
Format
next-server <address>
Mode DHCP Pool Config
no next-server
This command removes the boot server list.
Format
no next-server
Mode DHCP Pool Config
Utility Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
9-47