Virtual Router Redundancy Protocol Commands - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Term Definition
VLAN ID The identifier of the VLAN.
Logical Interface The logical unit/slot/port associated with the VLAN routing interface.
IP Address The IP address associated with this VLAN.
Subnet Mask The subnet mask that is associated with this VLAN.

Virtual Router Redundancy Protocol Commands

This section describes the commands you use to view and configure Virtual Router Redundancy
Protocol (VRRP) and to view VRRP status information. VRRP helps provide failover and load
balancing when you configure two devices as a VRRP pair.
ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the
router.
Default none
Format
ip vrrp
Mode Global Config
no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of VRRP on
the router.
Format
no ip vrrp
Mode Global Config
Routing Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
4-25