Igmp Proxy Commands; Ip Igmp-Proxy Unsolicit-Rprt-Interval - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

IGMP Proxy Commands

The IGMP Proxy is used by IGMP Router (IPv4 system) to enable the system to issue IGMP host
messages on behalf of hosts that the system discovered through standard IGMP router interfaces.
With IGMP Proxy enabled, the system acts as proxy to all the hosts residing on its router
interfaces.
ip igmp-proxy
This command enables the IGMP Proxy on the router. To enable the IGMP Proxy on the router,
you must enable multicast forwarding. Also, make sure that there are no multicast routing
protocols enabled on the router.
Format
ip igmp-proxy
Mode Interface Config
no ip igmp-proxy
This command disables the IGMP Proxy on the router.
Format
no ip igmp-proxy
Mode Interface Config

ip igmp-proxy unsolicit-rprt-interval

This command sets the unsolicited report interval for the IGMP Proxy router. This command is
valid only when you enable IGMP Proxy on the interface. The value of <interval> can be 1-
260 seconds.
Default 1
Format
ip igmp-proxy unsolicit-rprt-interval <interval>
Mode Interface Config
IP Multicast Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
5-35