Show Ipv6 Pimdm Neighbor - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Format
show ipv6 pimdm
Mode • Privileged EXEC
• User EXEC
Term Definition
Admin Mode Indicates whether PIM-DM is enabled or disabled.
Interface Valid unit, slot, and port number separated by forward slashes.
Interface-Mode Indicates whether PIM-DM is enabled or disabled on this interface.
Operational- The current state of PIM-DM on this interface. Possible values are Operational or Non-
Status Operational.
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 pimdm
Admin Mode..................................... Enable
PIM-DM INTERFACE STATUS
Interface Interface Mode
--------- --------------
0/1 Enable
0/2 Enable

show ipv6 pimdm neighbor

Use this command to display the PIM-DM neighbor information for all interfaces or for the
specified interface.
Format
show ipv6 pimdm neighbor [<unit/slot/port>|all]
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
Neighbor The IP address of the neighbor on an interface.
Address
IPv6 Multicast Commands
Protocol State
----------------
Non-Operational
Non-Operational
v1.0, July 2009
Managed Switch CLI Manual, Release 8.0
6-6