Aaa Authentication Dot1X - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Keyword
line
none
radius
tacacs
no aaa authentication enable
Note: If the default list is not set, only the enable password is checked. This has the same
effect as the following command:
aaa authentication enable default enable
On the console, the enable password is used if it exists. If no password is set, the
process will succeed anyway. This has the same effect as the following command:
aaa authentication enable default enable none
Use this command to remove the authentication method.
Format
no aaa authentication enable {default | list-name} method1
[method2...]
Mode Global Config

aaa authentication dot1x

This command is used to set authentication for dot1x users. The method argument identifies the
list of methods that the authentication algorithm tries, in the given sequence. The additional
methods of authentication are used only if the previous method returns an error, not if it fails. To
ensure that the authentication succeeds even if all methods return an error, specify
final method in the command line. For example if
after radius, no authentication is used if the radius server is down.
Format
aaa authentication dot1x default method1 [method2...]
Mode Global Config
Management Commands
Description
Uses the line password for authentication.
Uses no authentication.
Uses the list of all RADIUS servers for authentication. Uses username
"$enabx$."where x is the privilege level.
Uses the list of all TACACS servers for authentication. Uses username "$enabx$."
where x is the privilege level.
v1.0, July 2009
Managed Switch CLI Manual, Release 8.0
is specified as an authentication method
none
as the
none
10-39