Routing/Ipv6 Routing - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Table 11-35: CoS Log Message
Component Message
COS cosCnfgrInitPhase3Process: Unable to
apply saved config -- using factory defaults
Table 11-36: DiffServ Log Messages
Component Message
DiffServ diffserv.c 165: diffServRestore Failed to
reset DiffServ. Recommend resetting device
DiffServ Policy invalid for service intf: "policy name,
intIfNum x, direction y

Routing/IPv6 Routing

Table 11-37: DHCP Relay Log Messages
Component Message
DHCP relay REQUEST hops field more than config value The DHCP relay agent has processed a
DHCP relay Request's seconds field less than the config
value
DHCP relay processDhcpPacket: invalid DHCP packet
type: %u\n
Log Messages
Managed Switch CLI Manual, Release 8.0
Cause
The COS component was unable to apply
the saved configuration and has initialized to
the factory default settings.
Cause
While attempting to clear the running
configuration an error was encountered in
removing the current settings. This may
lead to an inconsistent state in the system
and resetting is advised.
The DiffServ policy definition is not
compatible with the capabilities of the
interface specified. Check the platform
release notes for information on
configuration limitations.
Cause
DHCP request whose HOPS field is larger
than the maximum value allowed. The relay
agent will not forward a message with a hop
count greater than 4.
The DHCP relay agent has processed a
DHCP request whose SECS field is larger
than the configured minimum wait time
allowed.
The DHCP relay agent has processed an
invalid DHCP packet. Such packets are
discarded by the relay agent.
v1.0, July 2009
11-17