Match Ethertype; Match Any; Match Class-Map - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

match ethertype

This command adds to the specified class definition a match condition based on the value of the
ethertype. The <ethertype> value is specified as one of the following keywords: appletalk,
arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe,
rarp or as a custom ethertype value in the range of 0x0600-0xFFFF.
Format
match ethertype {<keyword> | custom <0x0600-0xFFFF>}
Mode Class-Map Config
Ipv6-Class-Map Config

match any

This command adds to the specified class definition a match condition whereby all packets are
considered to belong to the class.
Default none
Format
match any
Mode Class-Map Config
Ipv6-Class-Map Config

match class-map

This command adds to the specified class definition the set of match conditions defined for another
class. The <refclassname> is the name of an existing DiffServ class whose match conditions
are being referenced by the specified class definition.
Default
none
Format
match class-map <refclassname>
Mode Class-Map Config
Ipv6-Class-Map Config
Quality of Service (QoS) Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
8-12