Show Igmpsnooping Querier - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

show igmpsnooping querier

Use this command to display IGMP Snooping Querier information. Configured information is
displayed whether or not IGMP Snooping Querier is enabled.
Format
show igmpsnooping querier [{detail | vlan <vlanid>}]
Mode Privileged EXEC
When the optional argument <vlanid> is not used, the command displays the following
information.
Field Description
Admin Mode Indicates whether or not IGMP Snooping Querier is active on the switch.
Admin Version The version of IGMP that will be used while sending out the queries.
Querier The IP Address which will be used in the IPv4 header while sending out IGMP queries. It
Address
can be configured using the appropriate command.
Query Interval The amount of time in seconds that a Snooping Querier waits before sending out the
periodic general query.
Querier Timeout The amount of time to wait in the Non-Querier operational state before moving to a
Querier state.
When you specify a value for <vlanid>, the following additional information appears.
Field Description
VLAN Admin Indicates whether iGMP Snooping Querier is active on the VLAN.
Mode
VLAN Indicates whether IGMP Snooping Querier is in "Querier" or "Non-Querier" state. When
Operational
the switch is in Querier state, it will send out periodic general queries. When in Non-
State
Querier state, it will wait for moving to Querier state and does not send out any queries.
VLAN Indicates the time to wait before removing a Leave from a host upon receiving a Leave
Operational
request. This value is calculated dynamically from the Queries received from the
Max Response
network. If the Snooping Switch is in Querier state, then it is equal to the configured
Time
value.
Querier Election Indicates whether the IGMP Snooping Querier participates in querier election if it
Participation
discovers the presence of a querier in the VLAN.
Querier VLAN The IP address will be used in the IPv4 header while sending out IGMP queries on this
Address
VLAN. It can be configured using the appropriate command.
Operational The version of IPv4 will be used while sending out IGMP queries on this VLAN.
Version
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-152