Captive Portal Status Commands - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Format
no interface <unit/slot/port>
Mode Captive Portal Instance Config mode
block
Use this command to block all traffic for a captive portal configuration. The administrator can
block access to a captive portal configuration. When an instance is blocked no client traffic is
allowed through any interfaces associated with that captive portal configuration. Blocking a
captive portal instance is a temporary command executed by the administrator and not saved in the
configuration.
Default no block
Format
block
Mode Captive Portal Instance mode
no block
Use this command to unblock traffic.
Format
no block
Mode Captive Portal Instance mode

Captive Portal Status Commands

This section describes commands that return captive portal status.
show captive-portal configuration
Use this command to display the operational status of each captive portal configuration.
Captive Portal Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
12-14